Specifications

B-509
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
show policy-map
Usage Guidelines The show policy-map command displays the configuration of a policy map created using the
policy-map command. You can use the show policy-map command to display all class configurations
comprising any existing service policy map, whether or not that policy map has been attached to an
interface. The command displays:
ECN marking information only if ECN is enabled on the interface.
Bandwidth-remaining ratio configuration and statistical information, if configured and used to
determine the amount of unused (excess) bandwidth to allocate to a class queue during periods of
congestion.
Examples This section provides sample output from typical show policy-map commands. Depending upon the
interface or platform in use and the options enabled (for example, Weighted Fair Queueing [WFQ]), the
output you see may vary slightly from the ones shown below.
Traffic Policing: Example, page B-510
Two-Rate Traffic Policing: Example, page B-510
Multiple Traffic Policing Actions: Example, page B-511
Explicit Congestion Notification: Example, page B-512
Percentage-Based Policing and Shaping: Example, page B-513
Bandwidth-Remaining Ratio: Example, page B-514
Tunnel Marking: Example, page B-515
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB, and the
command was modified to display information about Layer 2 Tunnel
Protocol Version 3 (L2TPv3) tunnel marking.
12.2(31)SB2 This command was enhanced to display bandwidth-remaining ratios
configured on traffic classes and ATM overhead accounting, and was
implemented on the Cisco 10000 series router for the PRE3.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SRC Support for the Cisco 7600 series router was added.
12.4(15)T2 This command was modified to display information about Generic Routing
Encapsulation (GRE) tunnel marking.
Note For this release, GRE-tunnel marking is supported on the
Cisco MGX Route Processor Module (RPM-XF) platform only.
12.2(33)SB This command was modified to display information about GRE-tunnel
marking, and support for the Cisco 7300 series router was added. This
command’s output was modified on the Cisco 10000 series router for the
PRE3 and PRE4.
Cisco IOS XE 2.1 This command was integrated into Cisco IOS XE Release 2.1 and was
implemented on the Cisco ASR 1000 series router.
12.4(20)T Support was added for hierarchical queueing framework (HQF) using the
Modular Quality of Service (QoS) Command-Line Interface (CLI) (MQC).
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Release Modification