Specifications

B-498
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
show mpls l2transport vc
show mpls l2transport vc
To display information about Any Transport over MPLS (AToM) virtual circuits (VCs) that have been
enabled to route Layer 2 packets on a router, use the show mpls l2transport vc command in privileged
EXEC mode.
show mpls l2transport vc [vcid vc-id] | [vcid vc-id-min vc-id-max]} [interface name
[local-circuit-id]] [destination ip-address | name] [detail]
Syntax Description
Command Modes Privileged EXEC
Command History
vcid (Optional) Allows you to enter a specific VC ID to display.
vc-id (Optional) The VC ID number.
vc-id-min
vc-id-max
(Optional) Range of VCs to display. The range is from 1 to 4294967295. (This
argument is primarily used for legacy implementations.)
interface (Optional) The interface or subinterface of the router that has been enabled to
transport Layer 2 packets. This keyword lets you display information about the VCs
that have been assigned VC IDs on that interface or subinterface.
name (Optional) Name of the interface or subinterface.
local-circuit-id (Optional) Number assigned to the local circuit. This argument value is supported
only by the following transport types:
• For ATM adaptation layer 5 (AAL5) and cell relay, enter the virtual path
identifier (VPI)/virtual channel identifier (VCI) of the PVC.
• For Ethernet VLANs, enter the VLAN number.
destination (Optional) Displays information about the VCs that have been assigned VC IDs for
the remote router you specify.
ip-address (Optional) IP address of the remote router.
name (Optional) Name assigned to the remote router.
detail (Optional) Displays detailed information about the VCs that have been assigned VC
IDs.
Release Modification
12.1(8a)E This command was introduced.
12.0(21)ST This command was integrated into Cisco IOS Release 12.0(21)ST.
12.0(22)S This command was implemented on the Cisco 10720 router.
12.0(23)S The interface and destination keywords were added.
12.2(14)S This command was integrated into Cisco IOS Release 12.2(14)S.
12.2(14)SX This command was implemented on the Supervisor Engine 720.
12.2(14)SZ This command was integrated into Cisco IOS Release 12.2(14)SZ.
12.2(15)T This command was integrated into Cisco IOS Release 12.2(15)T.
12.2(18)S This command was implemented on Cisco 7304 routers.