Specifications

4-6
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 4 Configuring the Cisco MWR 2941 Router Using the CLI
Configuration Sequence
Enabling the Interface
Note In the following procedure, press the Return key after each step unless otherwise noted. At any time,
you can exit the privileged level and return to the user level by entering disable at the Router# prompt.
After you configure the GE interface, enable it using the no shutdown command.by following this step
Router(config-if)# no shutdown
Creating Backup Switch Interfaces
You can use the following command to create a backup switch interface:
Router(config-if)# switchport backup interface interface_name preemption [forced |
bandwidth | off] delay [time]
For more information about this command, see switchport backup, page B-556
For instructions on how to create VLANs on GE interfaces, see Configuring VLANs, page 4-12.
Configuring Layer 2 Interfaces
The Cisco MWR 2941 has an onboard layer 2 Gigabit Ethernet switch and supports HWICs with layer
2 interfaces.To configure the layer 2 interfaces on the Cisco MWR 2941, complete the following tasks:
• Configuring a Range of Interfaces
• Defining a Range Macro
• Configuring Layer 2 Optional Interface Features
Configuring a Range of Interfaces
The interface-range command allows you to configure multiple interfaces at once. Follow these steps to
configure an interface range.
Step 1 Enter enable mode.
Router> enable
Router#
Step 2 Enter configuration mode.
Router# configure terminal
Router(config)#
Step 3 Use the interface-range command to select a range on interfaces to configure. You can specify a range
that includes both VLANs and physical interfaces.
Router(config)# interface range GigabitEthernet 0/1 - 3