Specifications

B-413
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
set precedence
The set precedence command is applied when you create a service policy in QoS policy-map
configuration mode. This service policy is not yet attached to an interface or to an ATM virtual circuit.
For information on attaching a service policy to an interface, refer to the “Modular Quality of Service
Command-Line Interface Overview” chapter of the Cisco IOS Quality of Service Solutions
Configuration Guide.
Related Commands Command Description
match dscp Identifies a specific IP DSCP value as a match criterion.
match precedence Identifies IP precedence values as match criteria.
match protocol Configures the match criteria for a class map on the basis of the specified
protocol.
policy-map Creates or modifies a policy map that can be attached to one or more
interfaces to specify a service policy.
service-policy Attaches a policy map to an input interface or VC, or an output interface
or VC, to be used as the service policy for that interface or VC.
set cos Sets the Layer 2 CoS value of an outgoing packet.
set dscp Marks a packet by setting the Layer 3 DSCP value in the ToS byte.
set qos-group Sets a group ID that can be used later to classify packets.
show policy-map Displays the configuration of all classes for a specified service policy map
or all classes for all existing policy maps.
show policy-map
interface
Displays the configuration for all classes configured for all service
policies on the specified interface or displays the classes for the service
policy for a specific PVC on the interface.
show table-map Displays the configuration of a specified table map or all table maps.
table-map (value
mapping)
Creates and configures a mapping table for mapping and converting one
packet-marking value to another.