Specifications

B-404
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
set ip precedence (route-map)
set ip precedence (route-map)
To set the precedence value (and an optional IP number or IP name) in the IP header, use the set ip
precedence command in route-map configuration mode. To leave the precedence value unchanged, use
the no form of this command.
set ip precedence [number | name]
no set ip precedence
Syntax Description
Command Default Disabled
Command Modes Route-map configuration
Command History
Usage Guidelines Table 14 lists the values for the number argument and the corresponding name argument for precedence
values in the IP header. They are listed from least to most important.
number | name (Optional) A number or name that sets the precedence bits in the IP header.
The values for the number argument and the corresponding name argument
are listed in Table 14 from least to most important.
Release Modification
11.0 This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Table 14 Number and Name Values for IP Precedence
Number Name
0 routine
1 priority
2 immediate
3 flash
4 flash-override
5 critical