Specifications

B-401

Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB

OL-21227-02

Appendix B Cisco MWR 2941 Router Command Reference

set ip precedence (policy-map configuration)

To set the precedence value in the IP header, use the set ip precedence command in policy-map

configuration mode. To leave the precedence value at the current setting, use the no form of this

command.

set ip precedence ip-precedence-value

no set ip precedence

Syntax Description

Command Default This command is disabled by default.

Command Modes Policy-map configuration

Command History

Usage Guidelines Table 13 lists the value definitions for precedence values in the IP header. They are listed from least to

most important.

ip-precedence-value Precedence-bit value in the IP header; valid values are from 0 to 7. See

Table 13 for a list of value definitions.

Release Modification

12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.

12.2(17d)SXB This command was implemented on the Supervisor Engine 2 and integrated

into Cisco IOS Release 12.2(17d)SXB.

12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.

12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.

12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.

Table 13 Value Definitions for IP Precedence

Values Definitions

0 routine

1priority

2 immediate

3flash

4 flash-override

5 critical

6internet

7network