Specifications

B-399

Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB

OL-21227-02

Appendix B Cisco MWR 2941 Router Command Reference

set ip dscp tunnel

To set the differentiated services code point (DSCP) value in the tunnel header of a Layer 2 Tunnel

Protocol Version 3 (L2TPv3) or Generic Routing Encapsulation (GRE) tunneled packet for tunnel

marking, use the set ip dscp tunnel command in policy-map class configuration mode. To disable this

functionality, use the no form of this command.

set ip dscp tunnel dscp-value

no set ip dscp tunnel dscp-value

Syntax Description

Command Default The DSCP value is not set.

Command Modes Policy-map class configuration (config-pmap-c)

Command History

dscp-value Number from 0 to 63 that identifies the tunnel header value. The following

reserved keywords can be specified instead of numeric values:

• EF (expedited forwarding)

• AF11 (assured forwarding class AF11)

Release Modification

12.0(28)S This command was introduced.

12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.

12.2(33)SRC This command was integrated into Cisco IOS Release 12.2(33)SRC.

12.4(15)T2 This command was integrated into Cisco IOS Release 12.4(15)T2, and

support for marking GRE-tunneled packets was included.

Note For this release, marking GRE-tunneled packets is supported only on

platforms equipped with a Cisco MGX Route Processor Module

(RPM-XF).

12.2(33)SB Support for marking GRE-tunneled packets was included, and support for

the Cisco 7300 series router was added.

12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.

12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.