Specifications

CHAPTER
4-1
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
4
Configuring the Cisco MWR 2941 Router Using
the CLI
This chapter describes how to use the Cisco IOS software command-line interface (CLI) to configure
the the Cisco MWR 2941 Mobile Wireless Edge Router and includes the following sections:
• Verifying the Cisco IOS Software Version, page 4-1
• Configuration Sequence, page 4-1
• Monitoring and Managing the Cisco MWR 2941 Router, page 4-107
For sample configurations, see Appendix A, “Sample Configurations.”
For additional configuration topics, see the Cisco IOS configuration guide and command reference
publications. These publications are available online at Cisco.com, or as printed copies that you can
order separately.
Note Be sure to review the Chapter 2, “Cisco IOS Software Basics,” before configuring your router; it
contains important information that you need to successfully configure your router.
Verifying the Cisco IOS Software Version
To implement the Cisco MWR 2941 router, Cisco IOS Release 12.4(19)MR2 or later must be installed
on the router. To verify the version of Cisco IOS software, use the show version command.
The show version command displays the configuration of the system hardware, the software version,
the names and sources of the configuration files, and the boot images.
Configuration Sequence
The “Summary of Steps” section on page 4-2 section provides the recommended primary configuration
sequence for the Cisco MWR 2941 router. These steps have configuration substeps (or tasks) within the
primary steps or tasks.
Note The installation of the Cisco MWR 2941 router and the Cisco T1/E1 interface card should be completed
before attempting the configuration (see the “Related Documentation” section on page xi for more
information).