Specifications

3-7
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 3 First-Time Configuration
Completing the Configuration
password ciscoenablesnmp-server community public !
no ip routing
!
interface GigabitEthernet0/1
shutdown
!
end
To complete your router configuration, do the following:
Step 1 A setup command facility prompt you to save this configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
[OK]
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
If you answer:
• no—The configuration information that you entered is not saved, and you return to the router enable
prompt. To return to the system configuration dialog, enter setup.
• yes—The configuration is saved, and you return to the EXEC prompt.
Step 2 When the messages stop displaying in your window, press Return to view the command line prompt.
The 2941-1> prompt indicates that you are now at the CLI and you have just completed a basic router
configuration. However, this is not a complete configuration. You must configure additional parameters
by using the Cisco IOS software CLI as described in Chapter 4, “Configuring the Cisco MWR 2941
Router Using the CLI.”