Specifications

Contents
vi
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Stopping and Starting Link Monitoring Operations 4-34
Configuring Link Monitoring Options 4-34
Configuring Global Ethernet OAM Options Using a Template 4-35
Configuring a Port for RFI Support 4-37
Configuring Ethernet Local Management Interface (E-LMI) 4-38
Enabling Ethernet LMI on All Supported Interfaces 4-38
Enabling Ethernet LMI on a Single Supported Interface 4-38
Configuring Clocking and Timing 4-39
Configuring PTP Clocking 4-39
Configuring Pseudowire-based Clocking with Adaptive Clock Recovery 4-45
Configuring Synchronous Ethernet 4-47
Configuring Network Clock Quality Selection Using REP 4-47
Verifying Clock-related Settings 4-49
Configuring MLPPP Backhaul 4-49
Configuring the Card Type 4-49
Configuring E1 Controllers 4-50
Configuring T1 Controllers 4-52
Configuring ATM IMA 4-53
Configuring a Multilink Backhaul Interface 4-54
Configuring Multiprotocol Label Switching (MPLS) 4-58
Configuring Routing Protocols 4-59
Configuring BFD 4-59
Configuring BFD for OSPF 4-59
Configuring BFD for BGP 4-61
Configuring BFD for IS-IS 4-61
Configuring BFD for Static Routes 4-63
Configuring IP Multicast 4-64
Configuring Multicast in Sparse Mode with a Static Rendezvous Point 4-64
Configuring Source-Specific Multicast 4-66
Configuring Source Specific Multicast Mapping 4-68
Configuring Multicast VPN 4-71
Verifying a Multicast Configuration 4-73
Configuring Pseudowire 4-73
Using Pseudowire Classes 4-74
Using CEM Classes 4-75
Configuring GRE Tunneling 4-76
Using Pseudowire Labels 4-77
Configuring a Backup Peer 4-78
Configuring Structure-Agnostic TDM over Packet (SAToP) 4-79
Configuring Circuit Emulation Service over Packet-Switched Network (CESoPSN) 4-79