Specifications

3-5
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 3 First-Time Configuration
Configuring Global Parameters
TOTAL: 0X06894CB0
If any of the above Memory requirements are “UNKNOWN”, you may be using an
unsupported configuration or there is a software problem and system operation
may be compromised.
Rounded IOMEM up to: 104Mb.
Using 20 percent iomem. [104Mb/512Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, 2900 Software (MWR2900-IPRAN-M),
Experimental Version 12.4(20050412:070057),
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Sat 10-Jan-09 03:19 by cbrezove
Image text-base:0x60008F60, data-base:0x6106A000
Cisco Systems, Inc. MWR-2941-DC (MPC8347E) processor (revision 0x400) with 41719
6K/107092K bytes of memory.
Processor board ID
MPC8347E CPU Rev: Part Number 0x8032, Revision ID 0x300
1 RTM Module: ASM-M2900-TOP daughter card
6 Gigabit Ethernet interfaces
1 terminal line
128K bytes of non-volatile configuration memory.
125440K bytes of ATA CompactFlash (Read/Write)
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 2 To begin the initial configuration dialog, enter yes when the following message appears:
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters:
Step 3 Enter a hostname for the router (this example uses 2941-1).
Configuring global parameters:
Enter host name [Router]: 2941-1
Step 4 Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
viewing the configuration.
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after