Specifications

3-4
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 3 First-Time Configuration
Configuring Global Parameters
Using the Setup Command Facility
The setup command facility appears in your PC terminal emulation program window. To create a basic
configuration for your router, do the following:
• Complete the steps in the Configuring Global Parameters, page 3-4.
• Complete the steps in the Completing the Configuration, page 3-6.
Note If you make a mistake while using the setup command facility, you can exit the facility and run
it again. Press Ctrl-C, and type setup at the enable mode prompt (1900#).
Configuring Global Parameters
Use the following procedure to configure global parameters.
Step 1 Power on the router. Messages appear in the terminal emulation program window.
Caution Do not press any keys on the keyboard until the messages stop. Any keys that you press during this time
are interpreted as the first command entered after the messages stop, which might cause the router to
power off and start over. Wait a few minutes. The messages stop automatically.
The messages look similar to the following:
Note The messages vary, depending on the Cisco IOS software image and interface modules in your
router. This section is for reference only, and output might not match the messages on your
console.
rommon 1 >boot
program load complete, entry point:0x80008000, size:0xc200
Initializing ATA monitor library.......
program load complete, entry point:0x80008000, size:0xc200
Initializing ATA monitor library.......
program load complete, entry point:0x80008000, size:0xc35eec
Self decompressing the image:
############################################################################
############################################################################
############################################################################
############################################################################
############################################################################
############################################################################
############################################################################
####################### [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQTYPE
0035C 0X005F3C00 MWR2941 Mainboard
0X000F3BB0 public buffer pools
0X00843000 public particle pools