Specifications

B-319
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
ql-enabled rep segment
ql-enabled rep segment
Specifies the REP segment used for synchronous Ethernet clock selection. For more information about
clock selection, see the “Configuring Network Clock Quality Selection Using REP” section on
page 4-47.
ql-enabled rep segment segment-id
no ql-enabled rep segment segment-id
Syntax Description
Command Default There is no default setting.
Command Modes Global configuration
Command History
Usage Guidelines This command requires that you specify a synchronous Ethernet clock source.
Examples The following example shows how to use the pw-pvc command:
Router# config t
Router(config)# ql-enabled rep segment 5
Router(config)# exit
Related Commands
segment Specifies a REP segment.
segment-id REP segment ID of the REP segment
Release Modification
12.2(33)MRA This command was introduced.
Command Description
rep segment Enables Resilient Ethernet Protocol (REP) on an interface assigns a
segment ID.