Specifications

B-316
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
ptp two-steps
ptp two-steps
The default PTP synchronization consists of a one-step handshake between the PTP master and slave
devices. The ptp two-steps command configures the master clock to send a follow-up message
containing the timestamp of the original synchronization message. This command is useful when the
Cisco MWR 2941 is acting as the PTP master and is connected to a slave device that requires a two-step
handshake.
ptp two-steps
no ptp two-steps
Note When configured as a PTP slave device, the Cisco MWR 2941 can use a one- or two-step handshake.
Command Default This command is disabled by default.
Command Modes Global configuration
Command History
Examples The following example shows how to configure a PTP two-step handshake:
Router# config t
Router(config-if)# ptp two-steps
Router(config)# exit
Related Commands
Release Modification
12.4(20)MR This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Command Description
ptp sync interval Defines the interval that the router uses to send PTP synchronization
messages.