Specifications

B-315
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
ptp tod
ptp tod
Configures the time of day message format used by the 1PPS interface.
ptp tod {iso8601 | ubx | nmea | cisco | ntp} delay-amount
no ptp tod {iso8601 | ubx | nmea | cisco | ntp} delay-amount
Syntax Description
Command Default The default configuration is ptp tod iso8601.
Command Modes Global configuration
Command History
Usage Guidelines This command applies only to the Cisco MWR 2941-DC-A; it does not apply to the Cisco MWR
2941-DC.
Examples The following example shows how to configure a PTP announcement interval.
Router# config t
Router(config)# ptp tod ubx 100
Router(config)# exit
Related Commands
iso8601 Specifies ISO 8601 time of day format.
ubx Specifies UBX time of day format.
nmea Specifies NMEA time of day format.
cisco Specifies Cisco time of day format.
ntp Specifies NTP time of day format.
delay-amount Delay in milliseconds between the 1PPS message and the time of day
message. Valid values are 1 to 999.
Release Modification
12.4(20)MR This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Command Description
ptp enable Enables PTP mode on an interface.
ptp mode Specifies the PTP mode.
ptp 1pps enable Configures the router to send or receive 1PPS time of day messages.