Specifications

B-306
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
ptp mode
ptp mode
Specifies the PTP mode.
ptp mode [ordinary]
no ptp mode [ordinary]
Note The Cisco MWR 2941 does not currently support other PTP modes such as boundary or transport mode.
Syntax Description
Command Default The default setting is ptp mode ordinary.
Command Modes Global configuration
Command History
Examples The following example shows how to enable ptp mode:
Router# config t
Router(config)# ptp mode ordinary
Router(config)# exit
Related Commands
ordinary Sets the interface to PTP clocking mode to ordinary.
Release Modification
12.4(19)MR2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Command Description
ptp enable Enables PTP mode on an interface.
ptp master Sets an interface in master clock mode for PTP clocking
ptp slave Sets an interface to slave clock mode for PTP clocking.