Specifications

B-299
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
ptp domain
ptp domain
PTP domains allow you to use multiple independent PTP clocking subdomains on a single network. Use
this command to specify the PTP domain number that the router uses.
ptp domain domain-number
no ptp domain domain-number
Syntax Description
Command Default The default setting is ptp domain 0.
Command Modes Global configuration
Command History
Examples The following example shows how to set the ptp domain:
Router# config t
Router# ptp domain 88
Router(config)# exit
Related Commands
domain-number PTP domain that the router applies to PTP traffic. Valid values are from 0 to
127.
Release Modification
12.4(19)MR2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Command Description
ptp enable Enables PTP mode on an interface.
ptp mode Specifies the PTP mode.