Specifications

B-274
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
police rate (control-plane)
police rate (control-plane)
To configure traffic policing for traffic that is destined for the control plane, use the police rate
command in QoS policy-map class configuration mode. To remove traffic policing from the
configuration, use the no form of this command.
police rate units pps [burst burst-in-packets packets] [peak-rate peak-rate-in-pps pps]
[peak-burst peak-burst-in-packets packets] [conform-action action]
no police rate units pps [burst burst-in-packets packets] [peak-rate peak-rate-in-pps pps]
[peak-burst peak-burst-in-packets packets] [conform-action action]
Syntax for Percent
police rate percent percentage [burst ms ms] [peak-rate percent percentage] [peak-burst ms ms]
no police rate percent percentage [burst ms ms] [peak-rate percent percentage] [peak-burst
ms ms]
Syntax Description units Specifies the police rate. If the police rate is specified in pps, the valid
range of values is 1 to 2000000 pps. If the police rate is specified in bps,
the valid range of values is 8000 to 20000000000.
pps Specifies that packets per seconds (pps) is used to determine the rate at
which traffic is policed.
burst burst-in-packets
packets
(Optional) Specifies the burst rate, in packets, used for policing traffic.
Valid range of values is 1 to 512000.
peak-rate peak-rate-in-pps
pps
(Optional) Specifies the peak information rate (PIR) used for policing
traffic and calculating the PIR. Valid range of values is 1 to 512000.
peak-burst
peak-burst-in-packets
packets
(Optional) Specifies the peak burst value, in packets, used for policing
traffic. Valid range of values is 1 to 512000.
bps (Optional) Specifies that bits per second (bps) is used to determine the
rate at which traffic is policed.
burst burst-in-bytes bytes (Optional) Specifies the burst rate, in bytes, used for policing traffic.
Valid range is from 1000 to 512000000.
peak-rate peak-rate-in-bps
bps
(Optional) Specifies the peak burst value, in bytes, for the peak rate.
Valid range is from 1000 to 512000000.
peak-burst
peak-burst-in-bytes bytes
(Optional) Specifies the peak burst value, in bytes, used for policing
traffic. Valid range is from 1000 to 512000000.
percent A percentage of interface bandwidth used to determine the rate at which
traffic is policed.
percentage Specifies the bandwidth percentage. Valid range is from 1 to 100.
burst ms
ms (Optional) Specifies the burst rate, in milliseconds, used for policing
traffic. Valid range is from 1 to 2000.
peak-rate percent
percentage
(Optional) Specifies a percentage of interface bandwidth used to
determine the PIR. Valid range is from 1 to 100.
peak-burst ms ms (Optional) Specifies the peak burst rate, in milliseconds, used for
policing traffic. Valid range is from 1 to 2000.