Specifications

B-251
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
network-clock-select wait-to-restore-timeout
network-clock-select wait-to-restore-timeout
Specifies the amount of time in seconds that the Cisco MWR 2941 waits before considering a new clock
source.
network-clock-select wait-to-restore-timeout duration
no network-clock-select wait-to-restore-timeout duration
Syntax Description
Command Default The default setting is network-clock-select wait-to-restore 300.
Command Modes Global configuration
Command History
Usage Guidelines The restore timer is a global timer value; it applies to both synchronous Ethernet clock sources when
configured.
Examples The following example shows how to use the network-clock-select command:
Router# config t
Router(config)# network-clock-select wait-to-restore 360
Router(config)# exit
Related Commands
duration Specifies the timer value in seconds. Valid values are 0–720 (up to 12
minutes). The default value is 300 seconds (5 minutes).
Release Modification
12.2(33)MRA This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Command Description
set network-clocks
force-reselect
Forces the router to re-select the network clock.