Specifications

B-249
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
network-clock-select input-stratum4
network-clock-select input-stratum4
The network-clock-select input-stratum4 command allows you to downgrade a clock source from
Stratum 3 to Stratum 4. To configure a clock source as Stratum 3, use the no form of this command.
network-clock-select input-stratum4
no network-clock-select input-stratum4
Command Default The default setting is for onboard E1/T1 ports is Stratum 3; the default setting for E1/T1 HWIC ports is
Stratum 4.
Note You cannot configure E1/T1 HWIC ports as Stratum 3.
Command Modes Global configuration
Command History
Examples The following example shows how to use the network-clock-select command:
Router# config t
Router(config)# network-clock-select input-stratum4
Router(config)# exit
Related Commands
Release Modification
12.4(19)MR2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Command Description
set network-clocks
force-reselect
Forces the router to re-select the network clock.