Specifications

B-223
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
mode (ATM/T1/E1 controller)
Command History
Usage Guidelines When a DSL controller is configured in ATM mode, the mode must be configured identically on both
the CO and CPE sides. Both sides must be set to ATM mode.
Note If using the no mode atm command to leave ATM mode, the router must be rebooted immediately to
clear the mode.
When configuring a DSL controller in T1 or E1 mode, the mode must be configured identically on the
CPE and CO sides.
To disable ATM mode on the T1/E1 controller after configuring an ATM pseudowire, you must remove
the xconnect statement from the ATM interface using the no xconnect command before issuing the no
mode atm command on the controller.
Examples
ATM Mode Example
The following example configures ATM mode on the DSL controller.
Router(config)# controller dsl 3/0
Router(config-controller)# mode atm
Release Modification
11.3 MA This command was introduced on the Cisco MC3810.
12.1(5)XM Support for this command was extended to the merged SGCP/MGCP
software.
12.2(2)T This command was integrated into Cisco IOS Release 12.2(2)T.
12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T for the
Cisco IAD2420.
12.2(2)XB Support was extended to the Cisco 2600 series and Cisco 3660. The
keyword aim and the argument aim-slot were added. The parenthetical
modifier for the command was changed from “Voice over ATM” to “T1/E1
controller.”
12.2(15)T This command was implemented on the Cisco 2691 and the Cisco 3700
series.
12.3(4)XD This command was integrated into Cisco IOS Release 12.3(4)XD on
Cisco 2600 series and Cisco 3700 series routers to configure DSL Frame
mode and to add T1/E1 Framed support.
12.3(4)XG This command was integrated into Cisco IOS Release 12.3(4)XG on the
Cisco 1700 series routers.
12.3(7)T This command was integrated into Cisco IOS Release 12.3(7)T on
Cisco 2600 series and Cisco 3700 series routers.
12.3(11)T This command was implemented on Cisco 2800 and Cisco 3800 series
routers.
12.3(14)T This command was implemented on Cisco 1800 series routers.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA. This
release does not support DSL HWICs.