Specifications

B-218

Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB

OL-21227-02

Appendix B Cisco MWR 2941 Router Command Reference

mep archive-hold-time

To set the amount of time, in minutes, that data from a missing maintenance end point (MEP) is kept in

the continuity check database or that entries are held in the error database before they are purged, use

the mep archive-hold-time command in Ethernet connectivity fault management (CFM) configuration

mode. To restore the default number of minutes, use the no form of this command.

Note Release 12.2(33)MRA supports the Draft 1.0 version of Ethernet CFM; it does not support the IEEE

802.1ag-2007 version.

mep archive-hold-time minutes

no mep archive-hold-time minutes

Syntax Description

Command Default The command is enabled, and the archive hold time is set to 100 minutes.

Command Modes

Cisco pre-Standard CFM Draft 1 (CFM D1)

Ethernet CFM configuration (config-ether-cfm)

CFM IEEE 802.1ag Standard (CFM IEEE)

Ethernet CFM configuration (config-ether-cfm)

Command History

Usage Guidelines When you reset the archive hold time, the new hold time applies only to entries in the database that occur

after the reset. Entries made before the hold time was reset are not affected by the change.

Different archive hold times can be set for MEPs in different domains.

Note A missing MEP is a remote MEP that sends a 0 expiration time in its continuity check or a

remote MEP whose entry in the local continuity check database expires after it exceeds its

lifetime.

minutes Integer from 1 to 65535 that specifies the number of minutes that data from

a missing MEP is kept before it is purged. The default is 100.

Release Modification

12.2(33)SRA This command was introduced.

12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.

12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.

12.2(33)SXI2 This command was integrated into Cisco IOS Release 12.2(33)SXI2. In this

release the command was supported only in CFM IEEE.

12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.