Specifications

B-205
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
match mpls experimental
To use the match mpls experimental command, you must first enter the class-map command to specify
the name of the class whose match criteria you want to establish. After you identify the class, you can
use one of the following commands to configure its match criteria:
• match access-group
• match input-interface
• match mpls experimental
• match protocol
If you specify more than one command in a class map, only the last command entered applies. The last
command overrides the previously entered commands.
For CBWFQ, you define traffic classes based on match criteria such as input interfaces, ACLs,
protocols, QoS labels, and EXP field values. Packets satisfying the match criteria for a class constitute
the traffic for that class.
To use the match mpls experimental command, you must first enter the class-map command to specify
the name of the class whose match criteria you want to establish.
Examples The following example specifies a class map called ethernet1 and configures the Multiprotocol Label
Switching (MPLS) experimental values of 1 and 2 to be used as the match criteria for this class:
Router(config)# class-map ethernet1
Router(config-cmap)# match mpls experimental 1 2
Related Commands Command Description
class-map Creates a class map to be used for matching packets to a specified class.
match access-group Configures the match criteria for a class map based on the specified ACL.
match input-interface Configures a class map to use the specified input interface as a match
criterion.
match mpls
experimental topmost
Matches the EXP value in the topmost label.
match protocol Matches traffic by a particular protocol.
match qos-group Configures the match criteria for a class map based on the specified protocol.