Specifications

B-170
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
ip pim bsr-border
ip pim bsr-border
To prevent bootstrap router (BSR) messages from being sent or received through an interface, use the
ip pim bsr-border command in interface configuration mode. To disable this configuration, use the no
form of this command.
ip pim bsr-border
no ip pim bsr-border
Syntax Description This command has no arguments or keywords.
Command Default The command is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines When this command is configured on an interface, no Protocol Independent Multicast (PIM) Version 2
BSR messages are sent or received through the interface. Configure an interface bordering another PIM
domain with this command to avoid BSR messages from being exchanged between the two domains.
BSR messages should not be exchanged between different domains, because routers in one domain may
elect rendezvous points (RPs) in the other domain, resulting in protocol malfunction or loss of isolation
between the domains.
Note This command does not set up multicast boundaries. It sets up only a PIM domain BSR message border.
Examples The following example configures the interface to be the PIM domain border:
interface ethernet 1
ip pim bsr-border
Release Modification
11.3 T The ip pim border command was introduced.
12.0(8) The ip pim border command was replaced by the ip pim bsr-border
command.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
12.2(33)MRB This command was integrated into Cisco IOS Release 12.2(33)MRB.