Specifications

B-155
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
ip igmp query-max-response-time
ip igmp query-max-response-time
To configure the maximum response time advertised in Internet Group Management Protocol (IGMP)
queries, use the ip igmp query-max-response-time command in interface configuration mode. To
restore the default value, use the no form of this command.
ip igmp query-max-response-time seconds
no ip igmp query-max-response-time
Syntax Description
Command Default seconds: 10 seconds
Command Modes Interface configuration
Command History
Usage Guidelines This command is valid only when IGMP Version 2 is running.
This command controls the period during which the responder can respond to an IGMP query message
before the router deletes the group.
Examples The following example configures a maximum response time of 8 seconds:
ip igmp query-max-response-time 8
Related Commands
seconds Maximum response time, in seconds, advertised in IGMP queries. The default
value is 10 seconds.
Release Modification
11.1 This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support in
a specific 12.2SX release of this train depends on your feature set, platform,
and platform hardware.
12.2(33)MRB This command was integrated into Cisco IOS Release 12.2(33)MRB.
Command Description
ip pim query-interval Configures the frequency of PIM router query messages.
show ip igmp groups Displays the multicast groups that are directly connected to the router and
that were learned through IGMP.