Specifications

B-106

Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB

OL-21227-02

Appendix B Cisco MWR 2941 Router Command Reference

ethernet cfm mip level

To provision a maintenance intermediate point (MIP) at a specified maintenance level on an interface,

use the ethernet cfm mip level command in interface configuration mode. To restore the default

configuration of the interface, use the no form of this command.

Note Release 12.2(33)MRA supports the Draft 1.0 version of Ethernet CFM; it does not support the IEEE

802.1ag-2007 version.

Cisco pre-Standard Connectivity Fault Management Draft 1 (CFM D1)

ethernet cfm mip level level-id

no ethernet cfm mip level level-id

CFM IEEE 802.1ag Standard (CFM IEEE)

ethernet cfm mip level level-id [vlan {vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}]

no ethernet cfm mip level level-id [vlan {vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}]

Syntax Description

Command Default No MIPs are configured.

Command Modes Interface configuration (config-if)

Command History

level-id Integer from 0 to 7 that specifies the maintenance levels at which MIPs can

be defined.

vlan (Optional) Indicates a VLAN for configuration.

vlan-id (Optional) Integer from 1 to 4094 that identifies the VLAN to be configured.

vlan-id-vlan-id (Optional) Integers from 1 to 4094 that define a valid range of VLANs to be

configured.

• The hyphen is required to separate the starting and ending VLAN ID

values that are used to define the range of VLAN IDs.

,vlan-id-vlan-id (Optional) Integers from 1 to 4094 that define a valid range of VLANs to be

configured.

• The comma is required to separate VLAN ranges.

Release Modification

12.2(33)SRA This command was introduced.

12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.

12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.