Specifications
B-54
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
controller
controller
To configure a T1, E1, or BITS controller and enter controller configuration mode, use the controller
command in global configuration mode.
controller {bits | t1 | e1 | shdsl} slot / port / subslot number / port number
Syntax Description
Command Default No T1 or E1 controller is configured.
Command Modes Global configuration
Command History
Related Commands
bits BITS controller
t1 T1 controller.
e1 E1 controller.
shdsl SHDSL controller.
slot/port Specifies the backplane slot number and port number. Refer to your hardware
installation manual for the specific values and slot numbers.
subslot
number
Specifies the subslot on the router in which the HWIC is installed.
port Specifies the port number of the controller. Valid numbers are 0 and 1. The slash
mark (/) is required between the slot argument and the port argument.
Release Modification
10.0 This command was introduced.
10.3 The e1 keyword was added.
12.0(3)T Support was added for dial shelves on Cisco AS5800 access servers.
12.2(7)XO The j1 keyword was added for the Cisco 2600 and Cisco 3600 series.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.4(19)MR2 This command was integrated into Cisco IOS Release12.4(19)MR2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA. This release
does not provide support for DSL HWICs.
Command Description
controllers shdsl Enters configuration mode for the SHDSL controller.
show controllers e1 Displays information about the E1 controller.
show controllers t1 Displays the total number of calls and call durations on a T1 controller.