Specifications

B-22
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
bandwidth (policy-map class)
The router converts the specified bandwidth to the nearest multiple of 1/255 (ESR–PRE1) or 1/65,535
(ESR–PRE2) of the interface speed. Use the show policy-map interface command to display the actual
bandwidth.
Restrictions
The following restrictions apply to the bandwidth command:
• The amount of bandwidth configured should be large enough to also accommodate Layer 2
overhead.
• A policy map can have all the class bandwidths specified in kbps or all the class bandwidths
specified in percentages, but not a mix of both in the same class. However, the unit for the priority
command in the priority class can be different from the bandwidth unit of the nonpriority class.
• When the bandwidth percent command is configured, and a policy map containing class policy
configurations is attached to the interface to stipulate the service policy for that interface, available
bandwidth is assessed. If a policy map cannot be attached to a particular interface because of
insufficient interface bandwidth, the policy is removed from all interfaces to which it was
successfully attached. This restriction does not apply to the bandwidth remaining percent
command.