Specifications

4-111
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 4 Configuring the Cisco MWR 2941 Router Using the CLI
Monitoring and Managing the Cisco MWR 2941 Router
– dnis—Enable SNMP DNIS traps.
– ds0-busyout—Enable ds0-busyout traps.
– ds1—Enable SNMP DS1 traps.
– ds1-loopback—Enable ds1-loopback traps.
– ds3—Enable SNMP DS3 traps.
– dsp—Enable SNMP dsp traps.
– eigrp—Enable SNMP EIGRP traps.
– entity—Enable SNMP entity traps.
– envmon—Enable SNMP environmental monitor traps.
– flash—Enable SNMP FLASH notifications.
– frame-relay—Enable SNMP frame-relay traps.
– hsrp—Enable SNMP HSRP traps.
– icsudsu—Enable SNMP ICSUDSU traps.
– ipmulticast—Enable SNMP ipmulticast traps.
– ipran—Enable IP-RAN Backhaul traps.
– ipsla—Enable SNMP IP SLA traps.
– isdn—Enable SNMP isdn traps.
– 12tun—Enable SNMP L2 tunnel protocol traps.
– mpls—Enable SNMP MPLS traps.
– msdp—Enable SNMP MSDP traps.
– mvpn—Enable Multicast Virtual Private Networks traps.
– ospf—Enable OSPF traps.
– pim—Enable SNMP PIM traps.
– pppoe—Enable SNMP pppoe traps.
– pw—Enable SNMP PW traps.
– rsvp—Enable RSVP flow change traps.
– snmp—Enable SNMP traps.
– srst—Enable SNMP srst traps.
– syslog—Enable SNMP syslog traps.
– tty—Enable TCP connection traps.
– voice—Enable SNMP voice traps.
– vrrp—Enable SNMP vrrp traps.
– vtp—Enable SNMP VTP traps.
– xgcp—Enable XGCP protocol traps.
For example, the following command specifies a recipient of the SNMP operation with a host-address
of 10.20.30.40 with a version SNMP of SNMPv2C:
Router(config)# snmp-server host 10.20.30.40 version 2c