Specifications

4-99
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 4 Configuring the Cisco MWR 2941 Router Using the CLI
Configuration Sequence
Step 6 Use one of the set commands listed in Table 6 to define a QoS treatment type.
Step 7 Exit configuration mode.
Router(config-pmap)# end
Router#
Note You can use the show policy-map or show policy-map policy-map class class-name commands to
verify your configuration.
Attaching the Policy Map to an Interface
Step 1 Enter enable mode.
Router> enable
Step 2 Enter the password.
Password: password
When the prompt changes to Router, you have entered enable mode.
Step 3 Enter global configuration mode.
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Step 4 Specify the interface to which you want to apply the policy map.
Router(config)# interface gigabitEthernet0/1
Step 5 Use the service-policy command to attach the policy map to an interface. The input and output
parameters specify the direction in which router applies the policy map.
Router(config-if)# service-policy input policy1
Step 6 Exit configuration mode.
Router(config-cmap)# end
Router#
Table 6 set Commands Summary
set Commands Traffic Attributes Network Layer Protocol
set cos Layer 2 CoS value of the
outgoing traffic
Layer 2 ATM
set dscp DSCP value in the ToS byte Layer 3 IP
set qos-group QoS group ID Layer 3 IP, MPLS