Specifications

4-90
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 4 Configuring the Cisco MWR 2941 Router Using the CLI
Configuration Sequence
The following limitations also apply when configuring classification on the Cisco MWR 2941.
• The following limitations apply to input Gigabit Ethernet interface QoS policies:
– You can use a the match vlan command with a maximum of 4 VLANs.
– You can use the match dcsp command with a maximum of 4 DSCP values.
– You cannot use the same match statement more than once in a single class map. For example,
you cannot add two match vlan commands to a single class map.
– You cannot use the match cos and match dscp commands together in a single class map.
• The following limitations apply to output Gigabit Ethernet interface QoS policies:
– Class maps only support matching based on qos-group. This limitation does not apply to the
class-default class map.
– You cannot create two policy maps that match based on the same qos-group value.
all
any X X X
any
class-map
cos X X
destination-
address
discard-class
dscp X X X
flow pdp
frde
frdlci
ip dscp X X
ip precedence
ip rtp
mpls
experimental
XX
not
packet length
precedence
protocol
qos-group X
source-
address
vlan X
Table 4-1 QoS Classification Limitations by Interface (continued)
GigabitEthernet HWIC-9ESW MLPPP HWIC-1GE-SFP HWIC-ADSL HWIC-SHDSL