Specifications

4-49
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 4 Configuring the Cisco MWR 2941 Router Using the CLI
Configuration Sequence
Verifying Clock-related Settings
Use the following commands to verify the clock settings
• show network-clocks—Displays information about the network clocks
• show controller—Displays the status of the controller, including clocking information.
• show ptp clock—Displays ptp clock information
• show ptp foreign-master-record—Displays PTP foreign master records
• show ptp parent—Displays PTP parent properties
• show ptp port—Displays PTP port properties
• show ptp time-property—Displays PTP clock time properties
• show cem circuit—Displays information about the CEM circuit
• show platform hardware—Displays the status of hardware devices on the Cisco MWR 2941.
• show platform hardware rtm—Displays the current status of the TOP module
Configuring MLPPP Backhaul
To configure an MLPPP backhaul, complete the following tasks:
• Configuring the Card Type, page 4-49
• Configuring E1 Controllers, page 4-50
• Configuring T1 Controllers, page 4-52
• Configuring a Multilink Backhaul Interface, page 4-54
Configuring the Card Type
Perform a basic card type configuration by enabling the router, enabling an interface, and specifying the
card type as described below. You might also need to enter other configuration commands, depending
on the requirements for your system configuration and the protocols you plan to route on the interface.
Note In the following procedure, press the Return key after each step unless otherwise noted. At any time,
you can exit the privileged level and return to the user level by entering disable at the Router# prompt.
To select and configure a card type, follow these steps:
Step 1 Enter enable mode.
Router> enable
Step 2 Enter the password.
Password: password
When the prompt changes to Router, you have entered enable mode.
Step 3 Enter global configuration mode.
Router# configure terminal