Specifications

4-38

Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB

OL-21227-02

Chapter 4 Configuring the Cisco MWR 2941 Router Using the CLI

Configuration Sequence

Configuring Ethernet Local Management Interface (E-LMI)

The following sections describe how to configure Ethernet LMI on the Cisco MWR 2941:

• Enabling Ethernet LMI on All Supported Interfaces

• Enabling Ethernet LMI on a Single Supported Interface

Enabling Ethernet LMI on All Supported Interfaces

Follow these steps to enable Ethernet LMI on all supported interfaces on the Cisco MWR 2941.

Step 1 Enter enable mode.

Router> enable

Step 2 Enter the password.

Password: password

When the prompt changes to Router, you have entered enable mode.

Step 3 Enter global configuration mode.

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Step 4 Use the ethernet lmi global command to enable Ethernet LMI on all interfaces.

Router(config)# ethernet lmi global

Step 5 Use the exit command to exit configuration mode.

Router(config)# exit

Router#

Enabling Ethernet LMI on a Single Supported Interface

Follow these steps to enable Ethernet LMI on a single supported interface on the Cisco MWR 2941.