Installation Guide

Important Safety Instructions
78-4002497-01 Rev F vii
Connecting to Utility AC Power
Important: If this equipment is a Class I equipment, it must be grounded.
 If this equipment plugs into an outlet, the outlet must be near this equipment,
and must be easily accessible.
 Connect this equipment only to the power sources that are identified on the
equipment-rating label, which is normally located close to the power inlet
connector(s).
 This equipment may have two power sources. Be sure to disconnect all power
sources before working on this equipment.
 If this equipment does not have a main power switch, the power cord connector
serves as the disconnect device.
 Always pull on the plug or the connector to disconnect a cable. Never pull on the
cable itself.
Connection to Network Power Sources
Refer to this equipment’s specific installation instructions in this manual or in
companion manuals in this series for connection to network ferro-resonant AC
power sources.
AC Power Shunts
AC power shunts may be provided with this equipment.
Important: The power shunts (where provided) must be removed before installing
modules into a powered housing. With the shunts removed, power surge to the
components and RF-connectors is reduced.
CAUTION:
RF connectors and housing seizure assemblies can be damaged if shunts are
not removed from the equipment before installing or removing modules from
the housing.
Grounding (Utility AC Powered Equipment in Pedestals, Service Closets, etc.)
This section provides instructions for verifying that the equipment is properly
grounded.
Safety Plugs (USA Only)
This equipment is equipped with either a 3-terminal (grounding-type) safety plug or
a 2-terminal (polarized) safety plug. The wide blade or the third terminal is provided
for safety. Do not defeat the safety purpose of the grounding-type or polarized
safety plug.