Installation Guide

Installing Optional Modules
78-4002497-01 Rev F 29
the signal flow will be as follows:
Option 2: If the module is oriented the following way,
the signal flow will be as follows:
5 Carefully plug the module into the socket. Be sure all the pins on the module
align with the pins holes in the directional coupler socket.
6 Clean decal area of any dirt or oil. Attach the appropriate decal shipped with the
module.
7 Do you need to set power passing on one or more drop ports?
If yes, refer to the procedure for enabling drop powering below.
If no, proceed to Mounting the Faceplate (on page 33).