Installation guide

Release Notes for Cisco Voice Interworking Service Module Release 3.0(0)

Part Number OL-2523-01 Rev. B0, January 9, 2004

Installation and Upgrade Procedures

b. put <FW file> POPEYE@SM_1_<slot number of card to upgrade>.FW

quit

Note Do not enter two put commands in the same TFTP session.

Step 3 Proceed to the “Installing VISM Software Updates with PXM1 Cards” section on page 33 to install the

download.

VISM Firmware Download Procedure for PXM1E and PXM45

Step 1 Access the image on the Cisco Website in order to download the image.

Step 2 Use the ftp node-ip command, where node-ip is the IP address of the node to which you want to

download the image, to download the image.

Step 3 Enter your username and password.

Step 4 Type cd C:FW to access the appropriate directory.

Step 5 Type bin.

Step 6 Use the put image-version, where image-version is the downloaded image from Step 1, to download

the image to your C:FW directory.

Step 7 Type bye to exit the download procedure.

Installing VISM Software Updates with PXM1 Cards

Software Release 3.0(0) for VISM/VISM-PR provides a procedure for the graceful upgrade (one in

which the existing VISM configuration is preserved throughout the upgrade procedure) from the earlier

VISM 2.0 release.

Caution Installing VISM software updates from VISM Release 2.2 with CALEA to VISM Release 3.0

without CALEA is not graceful.

Caution Temporary traffic loss occurs during Step 4 and Step 5 of the VISM graceful upgrade procedure of

the Upgrade Procedure for software Release 3.0(0) for VISM/VISM-PR.