Installation guide

29
Release Notes for Cisco Voice Interworking Service Module Release 3.0(0)
Part Number OL-2523-01 Rev. B0, January 9, 2004
Important Notes
Table 7 describes VISM software interoperability with other Cisco products.
Table 8 describes the software images available for Release 3.0(0) for VISM/VISM-PR.
Table 9 describes the software boot code and run-time firmware requirements for software Release
3.0(0) for VISM/VISM-PR.
PXM45
2
PXM45 3.0.0 3.0.0
RPM RPM 12.2(8)T4 12.2(8)T4
RPM IOS RPM IOS 12.2(8)T4 —
RPM/B RPM/B 12.2(8)T4 12.2(8)T4
RPM-PR RPM-PR 12.2(8)T4 12.2(8)T4
SES SES 3.0.00 1.0.16
1. CWM Release 10.4 does not support all of the new MIBs listed in the “VISM Management Information
Base” section on page 13.
2. This card is not compatible with VISM cards.
Table 6 VISM Software Interoperability (continued)
Product CW2000 Name Latest Firmware Min. Firmware
Table 7 Software Release 3.0(0) for VISM/VISM-PR Interoperability with Other Cisco Products
Cisco 3810 12.2(8)T1
AS5400 122-10.7
Virtual Switch Controller Software VSC 9.1.2/9.1.5
Table 8 Software Images for Release 3.0(0) for VISM/VISM-PR
Product Name Software Image Firmware Description
MGX-VISM-SW3000 003.000.000 vism_8t1e1_003.000.000.000.fw This image does not support the
CALEA
1
feature.
1. CALEA = Commission on Accreditation for Law Enforcement Agencies.
MGX-VISM-LISW3000 003.050.000 vism_8t1e1_003.050.000.000.fw
2
2. The CALEA implementation supports the CALEA law intercept confirmation interface.
Use this image for CALEA
1
feature
support.
Table 9 Software Release 3.0(0) for VISM/VISM-PR Software Boot and Run-time Firmware
Requirements
Board Pair Latest Boot Code Version Minimum Boot Code Version
MGX-VISM-8T1 vism_8t1e1_VI8_BT_3.1.00.fw vism_8t1e1_VI8_BT_3.1.00.fw
MGX-VISM-8E1 vism_8t1e1_VI8_BT_3.1.00.fw vism_8t1e1_VI8_BT_3.1.00.fw
MGX-VISM-PR-8T1 vism_8t1e1_VI8_BT_3.1.00.fw vism_8t1e1_VI8_BT_3.1.00.fw
MGX-VISM-PR-8E1 vism_8t1e1_VI8_BT_3.1.00.fw vism_8t1e1_VI8_BT_3.1.00.fw