Installation guide

Release Notes for Cisco Voice Interworking Service Module Release 3.0(0)

Part Number OL-2523-01 Rev. B0, January 9, 2004

Important Notes

cnfjtrinitdelay Configures the jitter buffer size.

cnfpncon Sets priority routing for a specified connection.

cnfprofelemvbd Configures the VBD profile element for a profile.

cnfprofelemvoice Configures the voice profile element for a profile.

cnfprofparams Configures a profile preference.

cnfrtpcon Modifies an existing static RTP VoIP trunking connection.

cnfvbdcodec Configures the VBD upspeed codec.

cnfvismmode Configures the initial operating mode for a VISM card.

cnfxgcppeer Configures the UDP port number used to send gateway-initiated messages to

the call agent.

delendpt Deletes an endpoint from a VISM card.

delendptloop Takes an endpoint out of a loopback condition.

delendpts Deletes a consecutive number of endpoints on the VISM card.

delmgcgrpprotocol Deletes an MGCP from a specified call agent redundancy group.

delport Deletes a virtual port between a VISM and PXM cards.

dspaal2profile Displays AAL2 profile type and profile number data.

dspalmcnf Displays the threshold data about the alarm statistics being collected.

dspalmcnt Displays the alarm counters and statistics on a line.

dspcasglareattrib Displays the direction of CAS calls and the glare policy for a specified

endpoint.

dspcaspackage Displays the MGCP packages configured to notify persistent observed CAS

events in the context of incoming and outgoing CAS calls on a specified

endpoint.

dspcasparamsource Displays an endpoint’s currently configured CAS-related timer source.

dspcastimers Displays the currently configured CAS timers for a specified endpoint.

dspconcnt Displays the counter configuration data of a connection.

dspendpt Displays data about a specified endpoint on a VISM card.

dspmngcidcnt Displays the managed CID count for a specified endpoint.

dspmonecanendpt Monitors ECAN activity for a specified endpoint.

Table 4 Modiﬁed CLI Commands for Software Release 3.0(0) for VISM/VISM-PR (continued)

Command Name