Installation guide

25
Release Notes for Cisco Voice Interworking Service Module Release 3.0(0)
Part Number OL-2523-01 Rev. B0, January 9, 2004
Important Notes
Table 4 describes the modified CLI commands contained in software Release 3.0(0) for
VISM/VISM-PR.
Table 4 Modified CLI Commands for Software Release 3.0(0) for VISM/VISM-PR
Command Name
addcid Adds an AAL2 CID on a VISM card.
addcon Adds a PVC connection between a VISM card and any SM or PXM card.
addendpt Adds an endpoint on a VISM card.
addendptloop Places an endpoint in a loopback condition in the TDM direction.
addendpts Adds multiple consecutive numbers of endpoints to a VISM card.
addmgcgrpprotocol Associates a call agent redundancy group to a gateway control protocol.
addport Adds a virtual port between a VISM and PXM cards.
addrscprtn Adds a resource partition for a virtual port.
addrtpcon Adds a static RTP VoIP trunking connection.
clrmngcidcnt Clears AAL2 counters.
cnfcascode Configures CAS idle code and seized code parameters for an endpoint.
cnfcasdialdelay Configures the VISM wait time (dial delay) for outpulsing digits to the PBX
after sending an off-hook event.
cnfcasendpt Associates an endpoint with a CAS variant.
cnfcasflashtime Configures the minimum and maximum CAS on-hook time periods for
incoming flash hooks on a specified endpoint.
cnfcasglareattrib Configures the direction of CAS calls and the glare policy for a specified
endpoint.
cnfcasglaretime Configures the CAS glare time for an endpoint.
cnfcasguardtime Configures the CAS guard time for an endpoint.
cnfcasoffhooktime Configures a minimum presence time, on an endpoint, for a CAS off-hook
pattern to be recognized as an off-hook signal.
cnfcasonhooktime Configures a minimum presence time, on an endpoint, for a CAS on-hook
pattern to be recognized as an on-hook signal.
cnfcaspackage Configures MGCP packages to notify persistent observed CAS events in the
context of incoming and outgoing CAS calls on a specified endpoint.
cnfcasparamsource Configures an endpoint’s CAS-related timer parameters source.
cnfcaswinktime Configures the CAS wink time parameters—minimum and maximum make
times, and minimum break time—for an endpoint.
cnfcodecjtrdelay Configures the jitter delay mode and initial delay value for a specified codec.
cnfcodecparams Configures codec parameters—codec packetization period, preference,
IANA registered codec type, and xGCP codec string—for AAL1 and IP
calls.
cnfcodectmpl Assigns a codec template to an entire VISM card.
cnfcon Configures a connection between a VISM card and an MGX 8000 Series
switch PXM card.
cnfendptcadence Configures cadence (digit tone) times for an endpoint.