Specifications
Contents
vii
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
CHAPTER
4 Preparing Service Modules for Communication 4-1
Configuration Quickstart 4-2
Managing Firmware Version Levels for Service Modules 4-3
Locating Cards that Need the Firmware Version Set 4-3
Initializing Service Modules 4-4
Verifying Card Firmware Version Levels 4-5
Selecting MPSM Interfaces and Services 4-7
Configuring MPSM-8-T1E1 Interfaces and Services 4-7
Configuring MPSM-T3E3-155 and MPSM-16-T1E1 Interfaces and Services 4-8
Establishing Redundancy Between Two Service Modules 4-8
Selecting a Card SCT 4-10
Selecting a Port SCT 4-12
CHAPTER
5 Preparing SRM Cards for Communications 5-1
Configuration Quickstart for Bulk Distribution on SRMs Configured for SONET/SDH 5-2
Configuration Quickstart for Bulk Distribution on SRMs Configured for T3 Interfaces 5-3
Setting Up SRM Lines 5-4
Bringing Up Lines 5-4
Configuring Lines on an SRM Card 5-5
Configuring a SONET/SDH Line 5-5
Configuring T3 Lines 5-7
Establishing Redundancy Between SONET/SDH Lines with APS 5-9
Linking Service Module Lines to SRM Channels, VTs, or VCs 5-12
Where To Go Next 5-18
CHAPTER
6 Preparing RPM Cards for Operation 6-1
Configuration Quickstart 6-1
Locating RPM Cards in the Switch 6-2
Understanding dspcds and dspcd Displays for RPM 6-2
Initializing RPM Cards 6-4
Verifying the Software Version in Use 6-8
Establishing Redundancy Between RPM Cards 6-9
Configuring SNMP on the RPM Card 6-10
Where to Go Next 6-11
CHAPTER
7 Managing Service Class Templates 7-1
Cisco SCTs 7-2