Specifications

E-7
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Appendix E Hardware Survey and Software Configuration Worksheets
Additional PXM1E Information Configuration Worksheet
Additional PXM1E Information Configuration Worksheet
Table E-5 lists the additional information you will need to configure PXM1E cards.
Note PXM1E cards operate only on MGX 8850 (PXM1E), Cisco MGX 8850/B, Cisco MGX 8830, and Cisco
MGX 8830/B switches. If you are configuring a MGX 8850 (PXM45) or Cisco MGX 8950 switch, you
do not need to fill out Table E-5.
Time zone Enter a zone
Time zone offset Hours to offset
PXM and SRM
1
Redundancy Options
Standalone configuration Primary or secondary
card set installed?
Upper bay SRM SRM-3T3 or SRME?
Bulk distribution?
Lower bay SRM SRM-3T3 or SRME?
Bulk distribution?
Redundant configuration
Upper bay SRMs SRM-3T3 or SRME?
Bulk distribution?
SRM line redundancy?
Lower bay SRMs SRM-3T3 or SRME?
Bulk distribution?
SRM line redundancy?
1. SRM cards do not operate in Cisco MGX 8950 switches.
Table E-4 General Switch Configuration Parameters (continued)
Feature Parameter Information Value to Configure
Table E-5 Additional PXM1E Card Configuration Parameters
Feature
Parameter
Information Value to Configure
Card type Front and back cards
installed
Standalone configuration Using intracard APS?
Redundant configuration APS connector
installed?
Card SCT SCT number
Line operation mode T1, E1, T3, or E3?