Specifications

11-3
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 11 Viewing and Responding to Alarms
Displaying Alarm Reports in the CLI
Note PXM1E do not support switching alarms. Therefore, the commands in this section do not apply to
MGX 8850 (PXM1E) and MGX 8830 switches.
To display a report of all switching alarms, enter the following command:
M8850_LA.8.PXM.a > dspswalms
The following example is a sample report showing no switching alarms.
M8850_LA.8.PXM.a > dspswalms
XBAR SWITCHING FABRIC ALARMS SUMMARY
Xbar Core Alarm Xbar Port Alarm Xbar Slot B/W alarm
Slot No. Critical Major Minor Critical Major Minor Critical Major Minor
------- -------- ----- ----- -------- ----- ----- -------- ----- -----
01 0 0 0 0 0 0 0 0 0
02 0 0 0 0 0 0 0 0 0
03 0 0 0 0 0 0 0 0 0
04 0 0 0 0 0 0 0 0 0
05 0 0 0 0 0 0 0 0 0
06 0 0 0 0 0 0 0 0 0
07 -- -- -- -- -- -- -- -- --
08 0 0 0 0 0 0 0 0 0
09 -- -- -- -- -- -- -- -- --
10 0 0 0 0 0 0 0 0 0
11 0 0 0 0 0 0 0 0 0
12 0 0 0 0 0 0 0 0 0
13 -- -- -- -- -- -- -- -- --
14 -- -- -- -- -- -- -- -- --
To display additional information on switch alarms, enter the following commands:
• dspXbarPlaneAlms
• dspxbarslotbwalms
To display a report for xbar alarms, enter the following command:
M8850_NY.7.PXM.a > dspdevalms XBARCORE -pslot *