Specifications

9-87
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 9 Switch Operating Procedures
Managing PXM1E and AXSM Card Diagnostics
Enter the dspdiagstatus command as shown in the following example:
Unknown.7.PXM.a > dspdiagstatus
Slot State Role
---- ----- ----
1 Idle UNKNOWN CARD ROLE
2 Idle UNKNOWN CARD ROLE
3 Idle UNKNOWN CARD ROLE
4 Idle UNKNOWN CARD ROLE
5 Idle UNKNOWN CARD ROLE
6 Idle UNKNOWN CARD ROLE
7 Ready ACTIVE CARD ROLE
8 Idle UNKNOWN CARD ROLE
9 Idle UNKNOWN CARD ROLE
10 Idle UNKNOWN CARD ROLE
11 Idle UNKNOWN CARD ROLE
12 Idle UNKNOWN CARD ROLE
13 Idle UNKNOWN CARD ROLE
14 Idle UNKNOWN CARD ROLE
15 Ready ACTIVE CARD ROLE
16 Idle UNKNOWN CARD ROLE
17 Idle UNKNOWN CARD ROLE
18 Idle UNKNOWN CARD ROLE
19 Idle UNKNOWN CARD ROLE
20 Idle UNKNOWN CARD ROLE
Type <CR> to continue, Q<CR> to stop:
Enabling and Disabling IMA Group ATM Cell Layer Parameters
The cnfatmimagrp allows you to enable and disable the following ATM cell layer parameters on an IMA
group:
• payload scrambling
• AIS
To configure ATM cell layer parameters on an IMA group, enter the cnfatmimagrp command as
follows:
cnfatmimagrp -grp <bay.group> -sps <PayloadScramble> -ais <aisMode>
In the following example, the user enables payload scrambling and AIS on the ATM IMA group 14 on
the PXM1E in the lower bay.
Unknown.7.PXM.a > cnfatmimagrp -grp 2.14 -sps 1 -ais 1
Table 9-37 describes the parameters for the cnfimagrp command.