Specifications

9-49
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 9 Switch Operating Procedures
Managing PXM1E Partitions
Step 4 To display the changed partition configuration, enter the dsppart command as described in the previous
section.
Note The current software release does not support dynamic changes to partitions. To begin using
changes to a resource partition, you need to delete the controller and then add the controller as
described in the Step 5 through Step 8 of this procedure.
Step 5 Display the available controllers with the dspcontrollers command, and write down the controller
settings for the controller you are about to delete. For example:
minConns Specifies the guaranteed number of connections.
On the PXM1E UNI/NNI, the ranges vary according to the line types, as follows:
• For OC3, T3, and E3 lines, the range is 10-27000.
• For T1 and E1 lines, the range is 10-13500.
On the AXSM series of cards, the range is 10 through the maximum number of
connections in the port group.
Note This parameter applies only to PXM1E and AXSM cards.
maxConns Maximum number of simultaneous connections allowed on this port. The range is
the same as described for the <minConns> parameter. This parameter must be set to
number that is greater than the number defined for <minConns>.
Note This parameter applies only to PXM1E and AXSM cards.
available
connections
Logical channel number. Range: 0–16000.
Note This parameter applies only to FRSM12 and MPSM cards.
minDlci Lowest data-link connection identifier (DLCI). A value that specifies the DLCI in a
Frame Relay network:
• Two-byte header—Range: 1–1023
• Four-byte header—Range: 0–8388607
The value specified must be n * 32768, where n is a number from 0 to 255.
Note This parameter applies only to FRSM12 and MPSM cards.
maxDlci Highest data-link connection identifier (DLCI). A value that specifies a DLCI in a
Frame Relay network:
• 2-byte header—Value range: 1 –1023
• 4-byte header—Value range: 0 –8388607
The value specified must be (n * 32768)-1, where n is a number from 1 to 256.
Note This parameter applies only to FRSM12 and MPSM cards.
ingPctBw Percentage of ingress bandwidth available to the connection. Range: 0–100 percent.
Note This parameter applies only to FRSM12 and MPSM cards.
egrPctBw Percentage of egress bandwidth available to the connection. Range: 0–100 percent.
Note This parameter applies only to FRSM12 and MPSM cards.
Table 9-23 Parameters for the cnfpart Command (continued)
Parameter Description