Specifications

9-48
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 9 Switch Operating Procedures
Managing PXM1E Partitions
egrmaxbw Egress maximum bandwidth. Enter the maximum percentage of the outgoing port
bandwidth that you want assigned to the controller. One percent is equal to 0.00001
units. For example, an <egrmaxbw> of 1000000 = 100%. The sum of the maximum
egress bandwidth settings for PNNI can exceed 100%, and must be more than the
sum of the egrminbw settings. Available bandwidth above the minimum bandwidth
settings is allocated to the operating controllers on a first-request, first-served basis
until the maximum bandwidth setting is met or there is insufficient bandwidth to
meet the request.
Note This parameter applies only to PXM1E and AXSM cards.
ingminbw Ingress minimum bandwidth. Enter the minimum percentage of the incoming port
bandwidth that you want assigned to the controller. One percent is equal to 0.00001
units. For example, an <ingminbw> of 500000 = 50%. The sum of the minimum
ingress bandwidth settings for PNNI must be 100% or less, and must be less than
the sum of the ingmaxbw settings.
Note This parameter applies only to PXM1E and AXSM cards.
ingmaxbw Ingress maximum bandwidth. Enter the maximum percentage of the incoming port
bandwidth that you want assigned to the controller. One percent is equal to 0.00001
units. For example, an <ingmaxbw> of 750000 = 75%. The sum of the maximum
ingress bandwidth settings for PNNI can exceed 100%, and must be more than the
sum of the ingminbw settings. Available bandwidth above the minimum bandwidth
settings is allocated to the operating controllers on a first-request, first-served basis
until the maximum bandwidth setting is met or there is insufficient bandwidth to
meet the request.
Note This parameter applies only to PXM1E and AXSM cards.
minVpi Minimum VPI number for this port. For UNI ports, enter a value in the range from
0 to 255. For NNI ports, enter a value in the range from 0 to 4095.
Note This parameter applies only to PXM1E and AXSM cards.
maxVpi Maximum VPI number for this port. For UNI ports, enter a value in the range from
0 to 255. For NNI ports, enter a value in the range from 0 to 4095. The value for
<maxVpi> cannot be less than for <minVpi>.
Note This parameter applies only to PXM1E and AXSM cards.
minVci Minimum VCI number for this port. Enter a number in the range from 32 to 65535.
To support features planned for the future, Cisco recommends setting the minimum
VCI to 35 or higher.
Note This parameter applies only to PXM1E and AXSM cards.
maxVci Maximum VCI number for this port. Enter a number in the range from 32 to 65535.
Note This parameter applies only to PXM1E and AXSM cards.
Table 9-23 Parameters for the cnfpart Command (continued)
Parameter Description