Specifications

9-44
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 9 Switch Operating Procedures
Managing Controllers
Step 3 To display all controllers on the switch and verify the added controller, enter the dspcontrollers
command.
MGX8850.7.PXM.a > dspcontrollers
Controller Bay Number: 0
Controller Line Number: 0
Controller VPI: 0
Controller VCI: 0
Controller In Alarm: NO
Controller Error:
MGX8850 System Rev: 02.00 Jul. 30, 2000 09:39:36 GMT
MGX8850 Shelf Alarm: NONE
Number of Controllers: 1
Controller Name: PNNITWO
Controller Id: 2
Controller Location: Internal
Controller Type: PNNI
Controller Logical Slot: 7
Deleting a Controller
To delete a controller, use the following procedure.
Step 1 Establish a configuration session at any user access level.
Step 2 Enter the delcontroller command to prevent the switch from using a specified controller.
Table 9-22 Parameters for the addcontroller Command
Parameter Description
<cntrlrId> Number that identifies a network controller. The numbers are reserved as follows:
• 2 = PNNI
• 3 = Label Switch Controller (LSC), also known as Multiprotocol Label Switch
Controller (MPLS). This option is not supported on PXM1E cards.
Note The controller ID (cntrlrId) must be the same as the controller type
(cntrlrType).
i Keyword indicating that this controller is internal.
<cntrlrType> Number that identifies a network controller. The numbers are reserved as follows:
• 2 = PNNI
• 3 = LSC (Label Switch Controller, also known as MPLS. This option is not
supported on PXM1E cards.
Note The controller type (cntrlrType) must be the same as the controller ID
(cntrlrId).
<lslot> The logical slot number on which the controller resides. For the PXM-45, lslot is 7
regardless of which card is active.
[cntrlrName] (Optional) A string to serve as a name for the controller.