Specifications

9-39
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 9 Switch Operating Procedures
Managing NCDP Clock Sources
U1.8.PXM.a > dspncdpport 6:1.1:1
Network clock mode : disable
Ncdp Vc status : down
Network clock vpi : 0
Network clock vci : 34
Admin cost : 10
Service Category : sig
PCR : 250
SCR : 150
MBS : 100
Table 9-20 describes the objects displayed by the dspncdpport command.
Deleting an NCDP Clock Source
Enter the delncdpclksrc <portid> [clocktype <e1 | t1>] command to delete a clock source from the
network. describes how to set the <portid> and [clocktype] parameters on all possible switches and
cards.
Table 9-20 dspncdpport Command Objects
Parameter Description
Network clock mode Displays whether NCDP is enabled or disabled on each port.
NCDP Vc status Displays whether the Ncdp VC is up or down.
Network clock VPI Displays the VPI of the signaling channel for each port.
Network clock VCI Displays the VCI of the signaling channel for each port.
Admin Cost Displays the routing cost of the port.
Service Category Displays the service category for the current NCDP port.
PCR Displays the PCR
1
for the port.
1. PCR = peak cell rate
SCR Displays the SCR
2
for the port.
2. SCR = sustained cell rate
MBS Displays the MBS
3
for the port.
3. MBS = maximun burst size