Specifications
9-9
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 9 Switch Operating Procedures
Managing ILMI
1 1 On 0 16 On 1 5 4
Step 4 To display the operational state of ILMI on all ports, enter the dsppnports command at the PXM prompt
as shown in the following example:
mgx8830a.1.PXM.a > dsppnports
Summary of total connections
(p2p=point to point,p2mp=point to multipoint,SpvcD=DAX spvc,SpvcR=Routed spvc)
Type #Svcc: #Svpc: #SpvcD: #SpvpD: #SpvcR: #SpvpR: #Total:
p2p: 0 0 0 0 0 0 0
p2mp: 0 0 0 0 0 0 0
Total=0
Summary of total configured SPVC endpoints
Type #SpvcCfg: #SpvpCfg:
p2p: 0 0
p2mp: 0 0
Per-port status summary
PortId IF status Admin status ILMI state #Conns
7.35 up up Undefined 0
7.36 up up Undefined 0
7.37 up up Undefined 0
7.38 up up Undefined 0
Type <CR> to continue, Q<CR> to stop:
10:1.1:1 up up UpAndNormal 0
The ILMI operational state is displayed as one of the following: Disable, EnableNotUp, or
UpAndNormal. When ILMI is disabled on the port, the operational status is Disable. When ILMI is
enabled on the local port but cannot communicate with ILMI on the remote port, the status is
EnableNotUp. In other words, the EnableNotUp status happens when ILMI is disabled on the remote
end. When ILMI is enabled and communicating with ILMI on the remote port, the ILMI state is
UpAndNormal.
Step 5 To display ILMI configuration data for a specific port, enter the dsppnilmi command at the PXM prompt
as follows:
mgx8830a.1.PXM.a > dsppnilmi <portid>
Replace portid using the format slot:bay.line:ifNum. Table 9-1 describes these parameters. The
following example shows the format of the dsppnilmi command report.
mgx8830a.1.PXM.a > dsppnilmi 10:1.1:1
Port: 10:1.1:1 Port Type: PNNI Side: network
Autoconfig: disable UCSM: disable
Secure Link Protocol: enable
Change of Attachment Point Procedures: enable
Modification of Local Attributes Standard Procedure: enable
Addressreg: Permit All
VPI: 0 VCI: 16
Max Prefix: 16 Total Prefix: 0
Max Address: 64 Total Address: 0
Resync State: 0 Node Prefix: yes
Peer Port Id: 16848897 System_Id : 0.80.84.171.226.192