Specifications
8-58
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 8 Managing PNNI Nodes and PNNI Routing
Managing CUGs
Step 4 To change the configuration for access outside of CUG membership, enter the cnfaddrcug command
using the following format:
mgx8830a.1.PXM1.a > cnfaddrcug <atm-address> <length> <plan> [-pref <cug-index>] [-oa
{disallowed|percall|permanent}] [-ia {disallowed|allowed}]
The cnfaddrcug command parameters are described in Table 8-22.
Step 5 Enter the dspaddrcug command to verify the changes made with the cnfaddrcug command.
Note The dspaddrcug command parameters are described in Table 8-20.
Table 8-22 cnfaddrcug Command Parameters
Parameter Description
atm-address Replace this parameter with the NSAP or E.164 address or prefix of a local UNI
interface.
length If the prefix or address you are assigning to a CUG uses the NSAP format, specify the
address length in bits. A full AESA is 160 bits (20 bytes times 8 bits). A shorter address
length indicates an ATM address prefix, which assigns all addresses with that prefix to
the CUG you specify.
If the prefix or address you are assigning to a CUG uses the E.164 format, specify the
prefix or address length in digits.
plan If the prefix or address you are assigning to a CUG uses the NSAP format, specify nsap.
If the prefix or address you are assigning to a CUG uses the E.164 format, specify e164.
cug-index Enter a unique CUG Index number for this prefix or address. The range is 1 to 65535.
-oa The -oa (outgoing access) option allows you to change the outgoing access configuration
to disallow outgoing calls, enable outgoing calls when an outgoing call specifically
requests outside access, or permanently enable outgoing connections as if they were
CUG membership connections.
For outgoing access, type one of the following words as needed:
• disallowed
• percall
• permanent
Default: disallowed
-ia The -ia (incoming access) option allows you to change the incoming access
configuration to allow or disallow incoming calls from outside the CUG membership.
For incoming access, type one of the following words as needed:
• disallowed
• allowed
Default: disallowed