Specifications

8-48
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 8 Managing PNNI Nodes and PNNI Routing
Displaying Node Configuration Information
47.0091.8100.0000.0030.ff0f.ef38.0030.ff0f.ef38.99/160
Type: host Port id: 17251106
47.0091.8100.0000.0030.ff0f.ef38.1111.1101.0001.01/160
Type: host Port id: 17251106
47.0091.8100.0000.0050.0fff.e0b8/104
Type: static Port id: 17635339
39.6666.6666.6666.6666.6666.6666.6666.6666.6666/152
Type: uni Port id: 17504267
mgx8830a.1.PXM.a >
Displaying PNNI Interface Parameters
Enter the dsppnni-intf command to display the service category-based administrative weight and
aggregation token parameters:
mgx8830a.1.PXM.a > dsppnni-intf [node-index] [port-id]
The following example shows the report for this command:
mgx8830a.1.PXM.a > dsppnni-intf 11:2.2:22
Physical port id: 11: 2.2:22 Logical port id: 17504278
Aggr token.......... 0 AW-NRTVBR........... 5040
AW-CBR.............. 5040 AW-ABR.............. 5040
AW-RTVBR............ 5040 AW-UBR.............. 5040
mgx8830a.1.PXM.a >
Table 8-17 describes the objects displayed for the dsppnni-intf command.
Displaying the PNNI Link Table
Enter the dsppnni-link command to show the PNNI link table.
mgx8830a.1.PXM.a > dsppnni-link [node-index] [port-id]
If you specify:
• Both <node-index> and <port-id>, the command displays information about that specific <port-id>
port.
• Only <node-index>, the command displays information about all PNNI link attached to the
<node-index> node.
• Without any options, the command displays all links attached to all PNNI nodes on this switching
system.
Table 8-17 Objects Displayed for the dsppnni-intf Command
Parameter Description
portid The Port Identifier.
token The 32-bit number used for link aggregation purpose.
aw The 24-bit number used as administrative weight on this interface. The maximum
possible value is a 24-bit unsigned integer.